Voltage Controlled State Variable Filter (Two Pole 12db/Octave)

This will add a ton of timbres to your bag of tricks. This filter is also known as a Universal Active Filter. You get simultaneous High Pass, Band Pass, and Low Pass filtering. You can, of course, cascade two of these to obtain higher order filtering. The control voltage portion is just about straight from a Bernie Hutchins design. I love this filter. I built two into a module and am really pleased with the results. Now my synth has two of my low pass filters and two of these... I'm in filter heaven.

OK, I went back in and got it to work with 8 to 10 volt peak to peak signal amplitudes and made it output 8 to 10 volts peak to peak (note that this is when the Resonance is turned up and the Q ringing adds a couple of volts). If you overdrive the input you get some really funky sounding timbres so give it a try. I'm going to try and build this circuit using the buffers in the LM13700 to replace IC1B and IC1C. If it sounds as good as the current design it will mean that I can build this with one LM13700 and one TL082 (slightly cheaper than the TL084) so we can all save a buck or two.

Voltage Controlled State Variable Filter Schematic

smaller image

Voltage Controlled State Variable Filter PCB Layout (Component Side View)

NOTE!! that R25, R26, and R28 are vertically mounted. I kludged them in after I went back and worked the gain up a bit. The two 10uF caps are not on the schematic and are present for power supply bypassing. NOTE THAT THE TWO CHIPS FACE OPPOSITE DIRECTIONS!! When I was experimenting with this circuit I put the power to a TL084 backwards and the chip got so hot that it melted my breadboard, destroying the chip in the process (no kidding).